Klaim Artikel Anda
Verifikasi kepemilikan artikel akademik
Apakah artikel-artikel ini milik Anda?
Daftarkan diri Anda sebagai author untuk mengklaim artikel dan dapatkan profil akademik terverifikasi dengan fitur lengkap.
Badge Verifikasi
Profil terverifikasi resmi
Statistik Lengkap
H-index, sitasi, dan metrik
Visibilitas Tinggi
Tampil di direktori author
Kelola Publikasi
Dashboard artikel terpadu
Langkah-langkah Klaim Artikel:
- 1. Daftar akun author dengan email akademik Anda
- 2. Verifikasi email dan lengkapi profil
- 3. Login dan buka menu "Klaim Artikel"
- 4. Cari dan klaim artikel Anda
- 5. Tunggu verifikasi dari admin (1-3 hari kerja)
Menampilkan 1–3 dari 3 artikel
Pengaruh Temperatur Hot Gun dan Sudut Kampuh V pada Hot Gas Welding Terhadap Kekuatan Uji Tekuk Sambungan Las HDPE
Ahmad Fauzi
; Elka Faizal
Mars: Jurnal Teknik Mesin, Industri, Elektro Dan Ilmu Komputer
Vol 3
, No 4
(2025)
The development of construction materials is currently very rapid, including in the manufacture of fishing boats that still use wood. As an alternative, High Density Polyethylene (HDPE) plastic can replace wood because of its various advantages. The process of making fishing boats uses the plastic welding method, where the material is heated close to the melting temperature with a welding gun. The welding rod melts due to heat and is pressed continuously while the welding gun moves backward. Thi...
Sumber Asli
Google Scholar
DOI
Pengaruh Kecepatan Translasi dan Temperatur Pemanas Landasan Pelat Pada Friction Stir Welding Terhadap Kekuatan Bending Sambungan Las AA1100
Mohammad Irfan Yudhistira
; Elka Faizal
Jurnal Kendali Teknik dan Sains
Vol 3
, No 3
(2025)
Alumunium AA1100 is widely used in flat plate products such as heat exchanger fins and lightweight structural panels, yet it’s welding process still requires optimization. This study aims to determine the effect of tool traverse speed and backing plate preheating temperature on the bending strength of AA1100 joints produced by Friction Stir Welding (FSW). Experiments were conducted at three levels of each factor with three replications per combination: traverse speeds of 10 mm/min, 20 mm/...
Sumber Asli
Google Scholar
DOI
Pengaruh Dosage Duration dan Press Station Down terhadap Cacat Unmolded Produk Shoulder Extrusion Tube pada Proses Compression Moulding
Rizki Ahmat Yunifianto
; Elka Faizal
Mars: Jurnal Teknik Mesin, Industri, Elektro Dan Ilmu Komputer
Vol 2
, No 5
(2024)
In the plastic molding industry, there is a compression molding process to make shoulder tubes for cosmetic products. This research was to determine the effect of dosage duration and press station down parameters on unmolded defects in shoulder extrusion tube products. This research method uses quantitative with an experimental approach. This method is carried out by varying parameter setting dosage duration of 0.25s, 0.30s, 0.35s and press station down of 4 bar, 5 bar, 6 bar. The result od the...
Sumber Asli
Google Scholar
DOI