Monitoring the nutritional status of infants at this time is mostly still using the manual method, by looking at anthropomeric standard books so that nutritional monitoring takes longer and is less practical. Babies need nutritional status based on age, weight, length of the baby (baby's height), and sex of the baby. To find out the nutritional condition of the baby, the author wants to develop a measurement tool for weight and length of the baby with the output data in Microsoft Excel. This study aims to design a baby's weight and length measurement tools with data output at Microsoft Excel and perform a function test. The process of detection in infants using ultrasonic sensors that serves to determine the height or length of the baby's body and load cell sensors to determine the baby's weight, then the LCD (Liquid Crystal Display) which displays the results of ultrasonic sensors and load cell sensors and Arduino Uno. The results of this study are an infant weight and height measurement tool with an arduino uno-based anthropometric index method with 2 ultrasonic sensors as height and length counters, and 1 load cell sensor as a weight calculator for infants that will later be displayed on the LCD screen.

The climatic chamber is a calibration medium for the thermohygrometer. This simple climatic chamber was built using the Arduino uno, DHT22 sensor, heater, and peltier. The climatic chamber was designed and manufactured well and cheaply. Climatic chamber testing of the design results is carried out to determine the success rate of the tool. Tests are carried out using the Madgetech data logger tool through monitoring or monitoring of temperature within a certain period of time. The results of temperature monitoring at two observed values, namely temperatures of 250C to 300C and temperatures of 300C to 350C, showed good results with the corresponding rhythm of temperature increase and temperature decrease. It's just that the decrease in temperature still takes longer than the increase in temperature. This shows that the heater can be said to be working optimally and the peltier is not fully working. So it is necessary to do further studies related to the peltier for the climatic chamber both in terms of number and characteristics.

<p class="Abstract">Hypo-hyperthermia tool is a devive that can stabilize body temperature which decreases or increases temperature dramatically. The design of hypo-hyperthermia devices has been made using Arduino Uno. Functional tests have also been carried out on the hypo-hyperthermia tool to determine the level of success and eligibility. This tool works by utilizing the flow of water to provide the temperature needed by the patient in order to obtain a normal temperature, namely by increasing the temperature of the blanket when the patient has hypothermia and lowering the temperature of the blanket when the patient has hyperthermia. The design of this hypo-hyperthermia tool uses Arduino uno as a processor and DS18B20 sensor for temperature readings. Heaters are also used as water heaters, condensers as water coolers, and water pumps to drive the water cycle from the appliance to the blanket and back to the appliance. The temperature and mode settings will be displayed on the LCD screen. Function test results obtained by comparing the value of the temperature reading in skin mode with a digital thermometer that is obtained an error value of 0.3%. This temperature difference is affected by the room temperature and body temperature of the patient which can change at any time. It was also obtained by comparison of the temperature reading values in blanket mode with a digital thermometer that is obtained the largest error value of 6% at a setting value of 25 °C and the smallest error value of 0.3% at a setting value of 30 °C. This temperature difference is influenced by the temperature of the room at the time of measurement on the blanket is also influenced by the thickness of the hose installed on the blanket, so that the cold temperature in the water is not absorbed properly.</p>