Perancangan Alat Safety Device untuk Mencegah Kerusakan Komponen Akibat Engine Overheat

Engine overheating is a critical condition that can cause damage to internal components, reduce operational efficiency, and lead to overall system failure. The absence of an automatic protection system is one of the primary factors contributing to damage. This study aims to design and test a temperature sensor-based safety device that can automatically cut off the engine's working system when the temperature exceeds the safe limit. The method used is descriptive statistical analysis to evaluate the effect of independent variables (operational time duration and workload) on the dependent variable (coolant temperature). The system was tested through water heating simulation using an electric heater and controlled by an Arduino Nano microcontroller, a MAX6675 temperature sensor. Testing was carried out with variations in power load (150, 300, 450, 600, and 750 Watts) and operational duration (20, 40, and 60 minutes). Temperature data were collected and analyzed using ANOVA to determine the effect of load and time on temperature increase. The results showed that the temperature increased significantly with increasing power load, with temperatures approaching 100°C at loads ≥450 Watts in less than 20 minutes. The load variable shows a significant effect on temperature (p < 0.05), while the duration of time shows a nonlinear but not statistically significant upward trend. The safety device is proven to be able to automatically disconnect the system when the temperature reaches the specified maximum limit, thus effectively preventing engine damage due to overheating.