Publication Search

Article history: Received 30 Mei 2020 Received in revised form 2 Juni 2020 Accepted 10 Juni 2020 Available online 12 Juni 2020 ABSTRACT Alcohol is the common name for organic compounds that have a hydroxyl group attached to carbon and hydrogen atoms. The alcohol that is commonly found in liquor is ethyl alcohol or it is also called ethanol, but it is usually referred to as alcohol alone. Drinks with an alcohol content of 40% can lose consciousness, leading to accidents for alcohol-affected drivers. To detect alcohol in the body using an alcohol tester. Researchers tried to make a measuring instrument for alcohol levels in the body using several components such as Arduino nano, MQ 3 sensor, OLED, charger module, battery, resistor, push button, and buzzer. The design of a portable alcohol level detector through breath can work well, namely the results of the reading of alcohol levels in the body by the MQ-3 sensor through the breath and displayed on the Oled Display in units of% BAC (Blood Alcohol Concentration), in the sample comparison of the alcohol level reading between Final project tool with a comparison tool alcohol tester obtained the percentage difference in an average of 0.01% BAC. Keywords: Alcohol, Arduino Pro Micro, MQ-3 Sensor, OLED, Charger Module, Battery, Resistor, Push Button, and Buzzer

The community's need for electricity is getting higher, so alternative energy sources such as solar heat are needed to replace energy sources from fossil fuels in meeting electricity needs. In this paper we design a two-axis solar tracker with an LDR sensor. A sun tracking system is a unit that is combined into one to control the position of the tracking device with the aim of making the surface of the solar panel module always facing the direction of sunlight. This research discusses the Prototype of the Sun Tracking System in Arduino Based Solar Power Generation Systems to get maximum solar energy. This system will make solar panels move automatically so that sunlight absorption can be maximized. The main control uses Arduino nano which gets input values ​​from the LDR sensor then is processed to the output system. With the control system method can automatically be seen the difference in the results of a fixed solar panel with a solar panel with a tracker, from the comparison we get a solar panel with a tracker to get more optimal results.  

Number of fish seed can be measured by means of conventional observation using eye senses. But when the fish seed measured pretty much it will take a long time (not efficient) and cause incorrect measurement results (inaccurate). The accuracy of calculation of fingerlings is crucial trust between seller and buyer.During this time a sensor is used to detect the amount of fish seed is passed through a transparent hose using a light sensor (Light Dependent Resistor) and photodiode sensors as infra red light receiver. The level of accuracy of the sensor lies in the intensity of the light beam is received so that the sensor will be impaired if airya murky and there are air bubbles pass through the sensor so that the fish count error occurs.This research will be conducted design counters the number of fingerlings using infra red phototransistor sensor with a frequency of 20KHz to fish and then processed using the logic matrix. Results matrix logic into the data input to be processed by a microcontroller as the basis of results of calculation of the amount of fish.Development model studies using models of R & D (research and development) that produce a product in the form of the final product. Experiments were carried out using the type and length of catfish fingerlings with a length of 3 cm to 5 cm. Fish seed count tool has been tested to catfish farmers in the village Siwarak Ungaran City.The trial results calculators fish seeds have difference of 3% of the calculated results Manual or accuracy of calculation results have fish reaches 97%, then a counter of fish seed is acceptable to be used by catfish farmers.