Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive

Student Student ; Bayu Wahyudi ; Supervisor Supervisor
International Journal of Health and Information Te... 📅 2025 Vol 2, No 1
Abstract
This research aims to design a Plasma Blood Separator that can separate plasma from red blood cells automatical-ly using an Optocoupler sensor and a specimen tube cutter. This sistem is equipped with an Arduino Uno as the microcontroller, a servo motor to clamp the hose, a servo to open the blood bag pressure, a series of push buttons to open the servo, and a buzzer to indicate the completion of separation After testing the Arduino Uno-based Plasma Blood Separator, all functions can work well by showing the results of three experiments that varied the length of the hose. The length of the hose that was varied was 30 cm, 50 cm, 70 cm. The estimated separation time was 20 seconds, 30 seconds, and 40 seconds for mode 1, The estimated separation time was 40 seconds, 60 seconds, and 80 seconds for mode 2,  In the results of the measurement of the voltage of the tool, the measurement results were obtained with a small percentage of error with a value of <5% and a high accuracy value with >90%..
Keywords
arduino; microcontroller; Optocoupler sensor; plasma blood; separator
How to Cite

Student Student, et al. (2025). Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive. International Journal of Health and Information Technology, 2(1).

Student Student; Bayu Wahyudi; Supervisor Supervisor, "Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive," International Journal of Health and Information Technology, vol. 2, no. 1, 2025.

Student Student; Bayu Wahyudi; Supervisor Supervisor. "Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive." International Journal of Health and Information Technology, vol. 2, no. 1, 2025.

Student Student; Bayu Wahyudi; Supervisor Supervisor. "Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive." International Journal of Health and Information Technology 2, no. 1 (2025).

Student Student, et al. (2025) 'Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive', International Journal of Health and Information Technology, 2(1).

Student Student; Bayu Wahyudi; Supervisor Supervisor. Design and Manufacturing of a Simple Plasma Blood Separator Based on Arduino Uno with Servo Motor Drive. International Journal of Health and Information Technology. 2025;2(1).

Artikel Terkait

Effectiveness of Prenatal Yoga in Reducing Low Back Pain Intensity during the Third Trimester of Pregnancy

Tri Wahyu Permata Sari; Nila Widya Keswara

IoT-Based Vital Signs Monitor Testing with a Vital Sign Simulator

Mohamad Sofie; Andi Kurniawan; Arwanda Aries Ermawanto

Baby Incubator Temperature Control With PID System

Lorensius Gah; Mohamad Sofie; Mohammad Rofi'i

Analysis of Factors That Influence The Regularity of Pregnant Women's Visits to Antenatal Care Services at Muara Tewe Regional Hospital

Paridah Paridah; Sulistiyah Sulistiyah

The Effect of Breathing Relaxation Techniques on Pain Intensity in Women in Active Phase 1 of Labor at GMIM Siloam Sonder Hospital

Indriani Sartika Raco; Anik Purwati

Gray Level Co-occurance Matrix for Blood Type Identification

Mawardatun Nisa S; Mohammad Rofii; Pramesti Kusumaningtyas
Tren Sitasi Jurnal