Rancang Bangun Infusion Device Analyzer Dilengkapi Tampilan Suhu dan Kelembapan Ruangan Berbasis Arduino

Infusion Device Analyzer is a tool for testing the performance of an infusion pump and Syringe Pump. This tool measures flow and occlusion provided by the infusion pump and syringe pump. So a tool is needed to calibrate the infusion pump and syringe pump according to applicable standards so that swelling does not occur in the patient. The design of this calibration tool can also be used as student learning material so that students can understand and comprehend the working principles of the Infusion Device Analyzer. This tool is made using the Arduino Uno control system and there is an occlusion and flow measurement display along with room temperature and humidity which will be displayed on the Nextiton 4'3 Inch LCD. Accompanied by an optocoupler sensor as a liquid flow detector and an MPX5700AP sensor as a liquid pressure detector which is equipped with a DHT22 sensor as a room temperature and humidity meter. This calibrator tool is also equipped with a solenoid valve to regulate the entry of fluid to be measured between flow or occlusion measurements. The function test results show that the flowrate measurement of 10 is 12ml/h, 50 is 54ml/h, 100 is 105ml/h while the occlusion with a rate of 100 is 2.66 psi and the tolerance value for the parameters is appropriate. Therefore, the tool created is close to the desired plan and can be used as a suitable comparison of whether a Syringe Pump or Infusion Pump tool is suitable after repairs or during maintenance. This tool can also be used in learning for students to understand the parts of the working principle of this tool.